80″ MULTI-PURPOSE COMBO RAMPS
80-Inch Combo Ramps are the “Triple Header” of Ramps – use them as service ramps in the garage, trailer ramps when loading, and wheel cribs for display or service. Weighing in at 22 Pounds per ramp, they can hold up to 1,500 pounds each, to a total underside of the vehicle, raising it 10 inches with an 8.5-degree angle of approach. The incline section of the Ramp can be removed to provide maximum access underneath the car.
If you flip the incline section over, it can be used as a trailer ramp to safely and easily get low-to-the-ground vehicles on and off your trailer. Simply place your existing ramps, or trailer door, on the notch of the Combo Ramps to reduce the angle of approach to 8.50 degrees.
Note that the successful use of this application will vary depending on the trailer and vehicle clearance. To learn more about what angle of approach you will need, see the calculator here. These ramps are constructed using an exclusive, patent process. They are 100% solid, high density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong yet durable. They will never rust, transfer heat or cold, and won’t skid or scuff your floors.
Sold As: Pair
Length: 80″ (2032mm)
Width: 14″ (355mm)
Height: 12-1/4″ (311mm)
Weight: 22 lbs. (10.0 Kgs)
Lift Height: 10″ (254mm)
Maximum Capacity: 1,500 lbs. (680 Kgs)
Maximum Tire Width: 12″ (305 mm)
Approach Angle Degree: 8.5°
Material: Expanded foam with traction coating
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.